Report Designer - Printer offsets

Printer offsets are perfect to help align your design to your pre-printed stationery. If you get a new printer then a small alignment may be needed to match your new printer driver.

TIP: Sometimes it is easier to set all the values to Zero, then print off a new copy and add offsets based on that new print off.

1. Select the document you wish to edit, then click Preview.
2. Preview the report or layout you want to amend, then click Printer Offsets.
   
   
   
   

   NOTE: By default, all measurements in the Printer Offsets window appear in inches. To change the measurements to millimetres click Options, then in the Measurement drop-down list select Millimeter.

   
   
   
3. Amend the Report-specific offsets as follows:
   
   

   To move the printing up	Decrease the top offset. |Use the keyboard to enter the value you want to use, or use the arrow buttons to change the value.
   To move the printing down	Increase the top offset. Use the keyboard to enter the value you want to use, or use the arrow buttons to change the value.
   To move the printing to the right	Increase the left offset. Use the keyboard to enter the value you want to use, or use the arrow buttons to change the value.
   To move the printing to the left	Decrease the left offset. Use the keyboard to enter the value you want to use, or use the arrow buttons to change the value.

   
   

    

   NOTE: We recommend only altering the Report specific options to control the current alignment task.
   
   
   
   

4. Click OK.
5. If the document prints correctly click Close.
6. When prompted to save the changes, click Yes.
7. If required, repeat steps 1 to 3 until you are happy with the alignment.
   
   

You've now successfully entered a printer specific offset.

If you need to move items by more than just a fine tune, please refer to the following article >

Upgrading your licence

Need a little more room? To add extra companies, users, employees, or more to your software licence, leave your details and we'll be in touch.

Leave your details